|
STEP 1
Pull the release pin back and thread the wire rope into one locking
channel
in the cable lock. STEP
2
Pass the wire rope "tail" through (or around) the anchor point
(Eyehook, Beam, or Purlin). STEP
3
Pull the release pin back and push the wire rope tail into the
second locking
channel in the cable lock. STEP
4
Prior to the load being applied, the wire rope can be adjusted in either
direction.
ADJUSTING THE CABLE LOCK
With the load off the wire rope
and the Cable Lock, push the release pin in the direction of the arrow
on the Cable Lock. This will release the locking pawl and allow
the wire rope to be moved freely in either direction. (After a load has
been applied it may be necessary to pull the cable slightly to disengage
the teeth of the pawl). Be sure the load is fully supported before
attempting an adjustment. |
